B & L Fence GALV PLUS System
  Home   |   The Galv Plus System   |   Comparison   |   A Quick Review   |   Products  

CONSIDER THE FOLLOWING EQUATION AS IT
RELATES TO THE CONSTRUCTION INDUSTRY:

  RUST   =   WEAKNESS   =   CONSTRUCTION DEFECT   =   LIABILITY  

Non-Galv Square Iron
Galv Plus
Exposed welds rust first

Flat surface allows moisture to sit and facilitate rusting process (cohesive forces of water molecules) rust is inevitable.
· Surface scratches breed rust.
· The porosity of powder coat allows sufficient moisture penetration to cause a whitish powder to come through and discolor the fence.
· Porosity of powder coat also allows sufficient moisture penetration to lift and crack it's baked-on shell.

· High maintenance costs (repainting, etc.)
· Premature replacement
· Unsightly (rusty) much of the time

 

 

Hot-dipped after fabrication:
· Rough and unsightly finish.
· Requires "weep" holes to allow gases to escape and prevent explosion, consequently, minimal amount of GALV is able to bypass escaping gases resulting in poor interior coverage.
· Weep holes remain open inviting RUST!!
· Weep holes weaken structural integrity
(less steel = less strength).
Inferior quality is costly and ever increasing in terms of dollars and liability.
We rejuvenate all welds with hand brush cold zinc galv
 
GALV PLUS system is covered in a continuous hot-dipped galvanized zinc coating that fuses with and is encapsulated by a baked on polyester coating (the "PLUS" in "GALV PLUS" - so tough a razor blade can't chip it off). (Unlike pre-galv or galv. after fabrication).
· Imperative in producing rust free iron; a must if rust is a concern. NOTE: "Revolution" iron, the undisputed leader in our revolution against rust provides maximum rust resistance because it allows moisture to roll off the sealed, element protected exterior (unlike common square iron).
Guaranteed not to rust...
· Naked or epoxy primer only
· 1 coat polyguard
· 1 coat epoxy primer and
1 coat polyguard
Warrant per Golden State Fence Co.
Always looks beautiful...
Our continuous hot-dipped galv / cold brush zinc process (after welding) is done so well, there is no loss of structural integrity (no weep holes / unlike galv. after fabrication)
· GALV PLUS is sealed and element protected; encapsulated by a baked-on polyester coat.
A Time Capsule!



Think long term:
We guarantee our product NOT TO RUST!

Revolution and Traditional

 

Home |  The Galv Plus System |  Comparison
A Quick Review |  Products

B&L Fence · 8739 Troy Street · Spring Valley, CA 91977 · Phone (619) 697-7446 · Fax (619) 466-2865

Internet Services